Lighting circuit

This material is " for information purposes " only. Strict rules govern what electrical work can be done without notification and inspection. Read more...

Radial circuits are used for domestic lighting, meaning that the supply cable runs from one fitting to the next until the last where it terminates. There are two types of radial circuit used but more often than not the system in any one house is a mixture of the two.

Loop type lighting circuit

In this type, a twin and earth cable runs from the consumer unit to each of the ceiling roses one after the other. From each rose, another cable is run to the switch which operates that light.

Junction box lighting circuit

In this type, the twin and earth cable runs to one junction box after another. From each junction box, one cable runs to the light and another runs to the switch for that light.

Loop and junction box lighting circuits

Be sure you know the rules before starting any work.

With 1 mm sq. cable, one circuit may serve up to 1200 Watts (12 X 100 Watt lamps) and must not exceed 95 m of cable length measured without the switch length. However, where there are long cable lengths, use 1.5 mm sq. cable instead which allows a maximum cable length of 110 m measured without the switch length. The fuse rating for these circuits is 5 amp with ordinary fuses or 6 amp with MCBs (miniature circuit breakers). Even if your circuits do not reach the maximum permissible load, it is normal to have at least a separate circuit for upstairs and downstairs. In the event of one fuse blowing, you will not be plunged into total darkness.

• The mains supply
• Power circuits
• Installing a light and switch