Bleeding radiators

You may only publish this article on your website, in your ezine, or in your newsletter if you adhere to the rules

< - - START - - >

Bleeding a radiator

Open vented syatem

For sealed systems, seek the services of a professional heating engineer

Cold radiator

If the top section of a radiator is cold when the heating is on, it is usually an indication that air has got into the system somewhere and has become trapped. Air in a radiator will rise to the top forming a pocket stopping the hot water from getting to that part.This can be released by bleeding the radiator,, but remember to turn the heating off first.

When air is bled or released from an open vented system, the water in the system will be topped up by the feed and expansion tank.

If a radiator in a sealed system needs bleeding the pressure in the system will be reduced. The system will, therefore, needed to be toped up. However, sealed systems are different from open vented ones and have no feed and expansion tank. The instruction manual for your system may have details of how to top up the system. If not, or if you have any doubts at all, contact a suitably qualified heating engineer.

Bleed the radiator

You will need a radiator key and an old rag. Radiator keys are readily available from DIY stores and ironmongers. Armed with the rag beneath, use the radiator key to slacken the air bleed valve which is at one end towards the top of the radiator. There will be a hissing sound as the air comes out. As soon as water begins to flow, close the vent again and wipe away any water. Take care not to get scalded – the water may be pretty hot. The heating can then be switched back on.

Air release valve

Some systems have an automatic air release valve fitted. This usually has a small red top which should be slack to enable the air to escape.

Radiators should not need frequent ‘bleeding’. If they do, air is getting in and this should be sorted out by a professional heating engineer.

< - - END - - >

The rules for publishing these articles are

The article including the resource details at the bottom must remain complete and unedited.
You may not add, rearrange or remove any element or change the context of the article.
You may not use the article in unsolicited email. Distribution may only be through opt-in email.
You must send a copy of the ezine or newsletter containing the article and/or the URL of the page on the website where you have published the article, to articles@diyfixit.co.uk
URLs in the article and the resource details must be set as hyperlinks.

If you do not wish to adhere to these rules, please do not use these articles

Thank you

If you would like to discuss reproducing these articles in any other way, please contact us by email - articles@diyfixit.co.uk