Filling holes and cracks in walls and ceilings 1

Holes and cracks in plaster

Small indents or gouges in the surface can be filled without further preparation.

Preparing the surface

cutting out cracksCracks and larger defects will need a little more prep work. Cut away any loose material with a craft knife or the edge of an old stripping knife to leave a sound surface. Cracks are best cut out to provide a good mechanical key for the filler.

Run your knife along the crack pointing into the wall first to the left then to the right. This will create an inverted V shape which, when filled, will hold itself in place far better.

Mixing filler

Mix filler into an easily workable paste – not sloppy. Using an old cup or similar container is far easier than mixing on a flat surface. Pour in some powder and add water whilst stirring to create a smooth paste. Alternatively, take the easy route and use a ready mixed filler. To save yourself a lot of sanding down and time, follow the technique below rather than the common one of over-filling to allow for shrinkage, and sanding back smooth

Using flexible filler or caulk

When filling cracks at internal angles or at the junction between skirtings/frames and walls, use flexible acrylic filler. This will allow for a little movement. It is applied using a mastic gun. You don’t have to be terribly neat as it is water soluble before it dries and can be simply smoothed using a wet finger or sponge.

Technique for filling

Put some filler on a board or other flat object.

Take up some of the filler across the end of your filling knife and scrape this down over the defect. With a little practice, you’ll find you can fill the hole or crack in one sweep of the knife leaving it fairly smooth and flush. The movement is similar to the way they remove the surplus fat from a flat griddle in a burger bar.

using hawk to hold fillerapplying filler with knife

Allow the filler to dry. All but the smallest repairs will shrink slightly below the surface.

Now repeat the operation in exactly the same way as before. This will take up the shrinkage and leave an almost ready to decorate surface.

Sanding the filler smooth

Use a sanding block to lightly sand the surface flush.

Wear a mask when sanding to prevent inhalation of dust.

Applying this second layer of filler is a lot easier and creates far less dust than the rubbing down of over-filled holes.

Don’t attempt to fill larger holes in one go. Build up the filler in manageable layers which stay put and don’t sag. Allow each layer to dry before adding the next.

Filling holes and cracks in walls and ceilings 2

Avoiding the Pain !

Top 10 Tips for
Employing a Tradesman

Your Must-Know Guide to avoid being ripped off by Rogue Traders

Builder's Blog Latest ...

Another Rant from Marty the Builder

Loft Shop